Siemens SICLOCK TC 400 Operating Instructions Manual page 49

Example of the /Display/View (0.10.01) parameter with the entries "Language"
and "Time":
Figure 7-2 Parameter view
Working with the configuration tool
To start the configuration tool:
1. Open the Web browser.
2. Enter the address of the device port, e.g. 192.168.1.10
3. If necessary, confirm the installation and execution of the applet with "Yes" or
"Always".
−> The configuration tool is started and displayed in the browser.
Note
Note the information in your browser about restrictions because of strict safety
settings.
To parameterize the SICLOCK TC 400 with the configuration tool:
1. Connect the configuration tool to the SICLOCK TC 400 with the
2. For a new parameterization of the device, load the parameters to the configu-
ration tool with the
the
3. Parameterize the SICLOCK TC 400 according to your hardware configuration
and your requirements.
In online mode, changes take effect immediately on the device.
4. Save the configuration as parameter file (*.u600) on your PC with the
Note
In order to be able to access the last version of the SICLOCK TC 400 parameter-
ization, we recommend that you save the current parameterization of SICLOCK
TC 400 as *.u600 file before you make any changes.
© Siemens AG 2007 All Rights Reserved
®
SICLOCK TC 400
button or open an existing parameter file (*.u600) with
button.
button.
Configuration Tool
button.
7-47