General Functions - Siemens SICLOCK TC 400 Operating Instructions Manual

Configuration Tool
7.2

General functions

The toolbar of the configuration tool provides general functions for the parameters
and the archive. You can also acknowledge events and authorize yourself on the
configuration tool.
Table 7-2 Operator options and displays in the toolbar of the configuration tool
Field/Button
Open
Save
IP address
Connect to device
Disconnect from device
Authorization - password
Authorize
Event
(online connection
required)
Acknowledge event
(online connection
required)
7-50
Load a parameterization/archive from the local file system
The file must be present in U600 format (*.u600). When opening, the
parameterization and the archive are loaded from the file.
Notice
The currently loaded data (parameterization and archive) is overwritten.
Save of a parameterization/archive to the local file system
The data (parameterization and archive) is saved in U600 format (*.u600).
IP address of the SICLOCK TC 400
You enter the IP address of the device here.
Connect to a device
The connection is established to the device with the specified IP address.
Disconnect from device
The established connection is disconnected.
See also Establish/disconnect online connection (Section 7.2.1).
Password input to activate a higher access level
Password of the device as delivered: "2222"
See also Authorization (Section 7.2.2).
Perform the authorization with the entered password
Events currently pending in the device
Events pending on the device (e.g. warnings, alarms, ...) are displayed in
online mode
No information is displayed in offline mode.
Acknowledge pending event
In online mode, an acknowledgement for the pending event is sent to the
device. If acknowledgeable, the device clears the event from the display.
Events that cannot be acknowledged (persistent messages) remain in the
display.
Meaning/Instruction
© Siemens AG 2007 All Rights Reserved
®
SICLOCK TC 400