Editing Dialog Box - Siemens SICLOCK TC 400 Operating Instructions Manual

To select a parameter for editing:
1. Navigate with the arrow keys
−> Depending on which key is pressed, the parameter list is scrolled up or
down in an endless loop.
The currently selected parameter is indicated by the
→
Language
ETH1 IP Address
2. Switch to the edit mode by pressing OK.
−> The editing dialog box is displayed.
Note
If no entry is made for 30 seconds, the display automatically switches to the oper-
ating display and you have to log on again in order to make entries.
8.2.3

Editing dialog box

Language
If you have selected "Language" in the parameter list, the following editing dialog
box appears:
Language:
German English
All texts in the display are shown in the language set here.
To change the language:
1. Select the desired language with the arrow keys
−> The currently selected language flashes.
2. Accept the selected language with OK.
−> The new setting is accepted and the parameter list is displayed again for
selection.
Ethernet settings
If you have selected an Ethernet setting in the parameter list, the following editing
dialog box appears, e.g. for "ETH3 IP Address":
ETH3 IP Address
192.168.3.30
© Siemens AG 2007 All Rights Reserved
®
SICLOCK TC 400
Parameterization and Operation on the Device
↑ ↓
to the desired parameter.
← →
∀→
" sign.
.
8-73