Restoring The As-Supplied Condition; Displaying The Software Version - Siemens Profiset 30isdn Operating Instructions Manual

Programming the telephone settings

Restoring the as-supplied condition

Displaying the software version

40
The Profiset 30isdn can be reset to the default settings.
To restore the as-supplied condition, it is absolutely nec-
essary to enter the password, also if it is still programmed
to 0000.
Enter 1 to restore the as-supplied condition (or 0 for no
reset):
a
Handset is on-hook.
S26
Start the programming procedure.
T
Enter the password.
0 or 1
Press key 0 or 1.
S
Exit the programming procedure.
If you contact the Siemens Service (
them the number of your software version as thus makes
the correction of defects a lot easier.
a
Handset is on-hook.
T
Enter the password if necessary.
S27
Start the programming procedure.
Software version is indicated on the display.
S
Display of software version is switched off.
"1" Restore the as-supplied condition.
"0" Do not restore the as-supplied condition.
Note:
If you restore the as-supplied condition, all pro-
grammed numbers and changed settings are
cleared.
page 44) please tell