Handset And Loudspeaker Volume; Call Processing Type - Siemens Profiset 30isdn Operating Instructions Manual

Programming the telephone settings

Handset and loudspeaker volume

or

Call processing type

30
You can set the volume of the handset and loudspeaker to
four levels (1...4: 1=minimum volume, 4=maximum vol-
ume). The volume is preset to level 2. You can set the vol-
ume via the digit keys or the +/- keys.
a
Handset is on-hook.
S23
Start the programming procedure.
1 ... 4
Press one of the keys 1 ... 4.
+ / -
Change the volume step by step via the +/- key.
S
Save the setting.
In the course of a call, you can change the volume via the
+/- key. The setting applys only to the current call.
The following settings are possible:
The telephone is preset to "Main station" .
a
Handset is on-hook.
S06
Start the programming procedure.
T
Enter the password if necessary.
0 or 1
Press key 0 or 1 .
S
Save the setting.
0 = Main station: If you were assigned MSNs by your
network operator, this is the correct call processing
type. Several devices with the same or different MSN
can be connected to a main station, whereby calls be-
tween these devices are liable for charges. "Main sta-
tion" is also the correct call processing type for oper-
ating at the majority of extensions (PBX).
1 = Point to point: Point to point connection =
system operation. In the event of a telephone system
failure, the telephone can be operated at a system
connection. In this emergency operation scenario, the
simple telephone functions can be activated. The
telephone rings with every incoming call at the sys-
tem connection irrespective of possibly entered
MSN.