Trunk Code For Operation At A Pbx; Multiple Subscriber Numbers (Msn) - Siemens Profiset 30isdn Operating Instructions Manual

Trunk code for operation at a PBX

Multiple Subscriber Numbers (MSN)

A trunk code must be defined if the Profiset 30isdn is op-
erated at a private branch exchange (PBX). In this case,
enter the digit(s) (maximum: two digits) used by the tele-
phone to access the public telephone network (see the
operating instructions of your PBX).
a
Handset is on-hook.
S24
Start the programming procedure.
T
Enter the password if necessary.
T
Enter the trunk code.
S
Save the setting.
You can enter up to three MSNs for your Profiset 30isdn.
Do not enter any country or area codes ! Entry of the
second and third MSNs is optional.
a
Handset is on-hook.
S01
Start the programming procedure.
T
Enter the password if necessary.
1 ... 3
Select MSN 1, 2 or 3.
T
Enter the MSN.
S
Save the setting.
Enter each MSN according to the above procedure.
Programming the telephone settings
If you want to program destination dialling,
speed dialling and direct station selection num-
bers ( page 26) you have to enter the relevant
trunk code before the call number (only in con-
junction with a PBX).
If it is not possible to dial a number from the call
list even though you have entered the correct
trunk code, delete the trunk code and try again.
31