Connections To The Plasmawall And Dhd Controller; Connecting The Plasmawall To The Dhd Controller - Runco PLASMAWALL XP-65DHD Owner's Operating Manual

Proceed as follows to connect the PlasmaWall to the DHD Controller, your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Connect the DHD Controller to the PlasmaWall as shown in Figure 3-3 and described in
the sections that follow.
SLOT1
Optional Terminal
Board Insert Slot
(covered)
Figure 3-3. Connecting the PlasmaWall to the DHD Controller
PlasmaWall XP-65DHD Owner's Operating Manual
AUDIO R AUDIO L
DVI-D IN COMPONENT/RGB IN
SLOT2 SLOT3
INPUTS
Serial No
R/Pr G/Y B/Pb H
Model
Video Processor / Controller
R/Pr G/Y B/Pb H
SDI
HDMI Out HDMI 1 HDMI 2 Option
HDMI OUT
P /C /R P /C /B Y/G
R R B B
AUDIO
PC IN
SYSTEM CONTROL INTERFACE
RISK OF ELECTRIC SHOCK
V AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
TRIGGERS
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
HD1
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
IR
1 2 3
HD2
WARNING:
TO REDUCE THE RISK OF FIRE
V OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
Pb Pr Y S-Video 1
100-230VAC 50-60 Hz, 165 Watts Max
Component Video Video S-Video 2 RS-232 Out RS-232 Control
RS-232
OUT
19
3.4
Connections to the
PlasmaWall and DHD
Controller
Connecting the
PlasmaWall to the DHD
Controller
SERIAL
CAUTION
!
DO NOT OPEN
Made In USA
Installation