Using The Dhd Controller Menus - Runco PLASMAWALL XP-65DHD Owner's Operating Manual

1. The native resolution of the XP-65DHD is 1920 x 1080. Other
Note
2. With most computers, you can get the best picture at
To prevent image retention (burn) on your display, ALWAYS use a
WARNING
screen saver and set it to the shortest possible time.
Press the MENU button on either the remote control or the DHD Controller front panel to
display the Main Menu. To select a menu item, use the UP (
on either the remote control or the DHD Controller front panel to highlight it. Press ENTER
to confirm your selection.
The PlasmaWall OSD menus are arranged hierarchically, as shown in Figure 4-1.
Depending on the selected input source and signal characteristics, some menu options
may not be available.
When the input signal resolution is 1080i analog (via the HD1 or
Note
HD2 input) or lower, the menus appear both on-screen and on the
front-panel display of the DHD Controller as you navigate them:
When the input signal resolution is 1080i digital or 1080p (via the
HDMI1 or HDMI2 input), the menus appear on the front-panel
display only.
PlasmaWall XP-65DHD Owner's Operating Manual
horizontal or vertical resolutions may be scaled upward or
downward to fit the display.
1024 x 768 @ 60Hz.
Input Source
Aspect Ratio
) and DOWN ( ) buttons
↑
↓
29
4.3
Using the DHD
Controller Menus
Operation