Connecting An External Ir Receiver To The Dhd Controller; External Ir Receiver Connection - Runco PLASMAWALL XP-65DHD Owner's Operating Manual

Installation
Connecting an External IR
Receiver to the DHD
Controller
➤
If infrared signals from the remote control cannot reach the DHD Controller due to
excessive distance or obstructions such as walls or cabinet doors, you can connect an
external IR receiver to the DHD Controller to extend the range of the remote control. See
Figure 3-11.
IR Receiver
Remote
Control
Figure 3-11. External IR Receiver Connection
Note
SYSTEM CONTROL INTERFACE
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
TRIGGERS
CAUTION:
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
IR
1 2 3
WARNING:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
S-Video 1
100-230VAC 50-60 Hz, 165 Watts Max
Video S-Video 2 RS-232 Out RS-232 Control
Ring = +5V
Tip = IR Input
Sleeve = Ground
(3.5-mm
mini phono
plug)
When an external IR receiver is connected to the wired IR input, the
built-in IR sensor on the DHD Controller is disabled.
26 PlasmaWall XP-65DHD Owner's Operating Manual
CAUTION
!
RISK OF ELECTRIC SHOCK
DO NOT OPEN
TO REDUCE THE RISK OF ELECTRIC
Made In USA