Dhd Controller Front Panel - Runco PLASMAWALL XP-65DHD Owner's Operating Manual

Figure 2-3 shows the controls and indicators on the DHD Controller front panel; the
paragraphs that follow describe them.
1 2
Figure 2-3. DHD Controller Front Panel
1. RUNCO ICON
Lights red to indicate that the DHD Controller is in standby mode; lights blue to
indicate that the unit is on.
2. POWER BUTTON
Press once to toggle from standby mode to on mode. Press it again to return to
standby mode. For a discrete on or off command, you can use the direct access
buttons on the remote control.
3. IR SENSOR
Receives IR commands from the remote.
4. VACUUM FLUORESCENT DISPLAY
Can be used instead of the On-Screen Display (OSD). Displays currently-selected
menu or – if no menu is selected – the current source, signal format (NTSC or PAL)
and aspect ratio.
5. UP BUTTON
Used to direct select aspect ratios or move the menu cursor up in the OSD. When no
menu is present on-screen, the UP button toggles through aspect ratios in the
following order:
16:9 - 4:3 - Letterbox - VirtualWide - Cinema
6. LEFT BUTTON
Used to direct select inputs or move the menu cursor left in the On-Screen Display.
When no menu is present on-screen, the LEFT button toggles through the different
sources, in this order:
HDMI 2 - HDMI 1 - HD/RGB 2 - HD/RGB1 - Component SD - S-Video 2 - S-Video 1
- Composite
7. ENTER BUTTON
Press ENTER to select a highlighted menu item.
PlasmaWall XP-65DHD Owner's Operating Manual
3 4 5 6 7
7
Controls and Functions
2.2
DHD Controller Front
Panel
8 9 10