Compare Button; Function Buttons - Korg microSTATION Operation Manual

10
11 12
13
9
9. Sequencer
The buttons in this section are used for operations in
Sequencer mode, such as recording and playback.
(p. 32).
LOCATE button
REC button
KEY button
WA
(Start/Stop) button
E R
(REW)/ (FF) button
D
(Pause) button
LOOP button
10.Display
This shows the names of programs or combinations, or
the values of parameters.
11.WRITE button
This button saves the program or combination.

12.COMPARE button

This button compares the sound or recording take
with the unedited or previous take.
(p. 8 "COMPARE button ‐ the Compare function")
13.CURSOR/VALUE
buttons
Use these buttons to select the page or parameter
shown in the display, or to edit a value.

14.Function buttons

PLAY/MUTE button
If this button is on (the LED to the left of the button
will light‐up), you can use the function buttons 01–16
to control the play/mute status of the oscillators,
timbres, and tracks. The function 01–16 LEDs will
indicate play/mute status of the corresponding item.
15
Front and rear panels Front panel
14
GRID SEQ button
If this button is on (the LED to the left of the button
will light‐up), the Grid Sequence function in Sequencer
mode will be on. This lets you use the function buttons
01–16 and LEDs 01–16 to easily create drum patterns.
NUM LOCK button
If this button is on (the LED to the left of the button
will light‐up), function buttons 01–16 will operate as
numeric keys, a clear button, an enter button, and as
group up/down buttons when selecting a program or
combination.
Function buttons 01–16
When the three buttons described above are off
(normal state), you can use these buttons to do the
following.
• To select programs or combinations.
• (When the TIMBRE/TRACK LED is lit) To select a
timbre or track.
15.Function LEDs
Function 01–16 LEDs
When the three buttons described above are off
(normal state), these LEDs indicate the following.
• An LED will light‐up to indicate the number within
the currently selected program or combination
category.
• (When the TIMBRE/TRACK LED is lit) An LED will
light‐up to indicate the timbre or track that's
currently selected for editing.
TIMBRE/TRACK LED
This will light‐up when the function 01–16 buttons and
LEDs can be used to select timbres or tracks.
GRID SEQ LED
This will light‐up in Sequencer mode when you press
the GRID SEQ button to turn on the Grid Sequence
function.
3