Korg microSTATION Operation Manual page 43

turn off the Grid Sequence function and use SEQ
EDIT: Track Edit ‐ Edit Time Sig, or press the REC
button and use the "TS" field to change the time
signature for recording.
4. Press the Start/Stop button to start playback.
At this point, all grid notes are off, so you won't
hear anything, but you'll notice that the function
LEDs will be lit‐up.
During playback, function 01–08 LEDs indicate the
location, and function 09–16 LEDs indicate the
status of each grid note. These LEDs will blink in
time with the playback tempo and quantize
settings.
Example 1) Loop: 01–002 (two measures), "TS": 4/4,
"Q": 8th ( )
First measure
Successively lit from left to right
Second measure
Successively lit from left to right
Example 2) Loop: 001–002 (two measure), "TS": 4/4,
"Q": 16th ( )
First measure - Beat 1–2
Successively lit from left to right
First measure - Beat 3–4
Successively lit from left to right
Second measure - Beat 1–2
Successively lit from left to right
Second measure - Beat 3–4
Successively lit from left to right
5. Press the Start/Stop button to stop.
Now let's create the drum pattern shown below.
MIDI recording Grid Sequence function
Loop: 001–002 (two measures), "TS": 4/4, "Q": 8th ( )
#
+ + + + + + + + + + + + + + + 
Open hi-hat (A 3)
#               
Close hi-hat (F 3)

Snare (D3) + + + + +

Kick (C3) + + +
6. Specify the looped measures and the quantization
as follows.
•"LpEnd": 2
•"Q": 8th ( )
Note: Use the  buttons to move between pages.
Use the  buttons to select parameters.
(p. 7 "Selecting a parameter and editing its
value")
7. Set the tempo and tempo mode as follows.
•Tempo: 080.00
•Tempo mode: Manu
8. First, enter the kick. Hold down the KEY button,
and press the C3 key. You can also use "KeySelect"
to specify the note to enter.
The velocity used when you strike the key is used as
the velocity value of the note that's entered. You can
also use "Init Vel" to specify the velocity.
9. Now you can enter the desired grid notes. Press
the function 01 button to choose the first location,
and then press the function 09, 13, and 14 buttons
to turn on the corresponding grid notes.
The function 09, 13, and 14 LEDs will light‐up.
The function 09–16 buttons will turn on or off each
time you press them.
10.Press the function 09 button to specify the second
location, and then press buttons 09, 13, and 14
buttons to turn on the corresponding grid notes.
The function 09, 13, and 14 LEDs will light‐up.
+
 
+ + +  +
+ + +
    
+ + + + + + +
39