Table of Contents
Advertisement
VN-C30U Installation and Setup
Before starting installation and setup
It is necessary to set an IP address for each VN-C30U unit. Use the following
procedure for the setup of each unit. (If the power is not turned on, the
installation of multiple VN-C30U can be performed at one time.)
1. Install the VN-C30U
In case of installation in a location where the power cannot easily be
turned on, complete steps 2 - 5 before step 1.
2. Connect the VN-C30U to the network, and set MODE SW as
outlined on the next page.
(The power to the VN-C30U should be ON.)
3. Set the VN-C30U IP address.
When setting the VN-C30U IP address, be sure to contact the network
administrator for assignment or approval. When installing the second
and following units, reboot the PC and then return to step 2.
4. Enable the VN-C30U IP address.
(Turn the VN-C30U power off and then on again.)
5. Register the connection point.
This registers the VN-C30U IP address data in the PC.
Names of VN-C30U parts
Rear view
100BASE-TX
10BASE-T/
DC12V
DC 12 V IN jack
10BASE-T/100BASE-TX port
12
Side view
Lens unit
Body
Alarm IN/OUT jack
Front view
Lens cover
Bottom view
MODE SW
M
H 10
1
3 2
A
F 100
Advertisement
Table of Contents
