JUKI DDL-8700 Instruction Manual page 8

!3
!4
How to fix cable clip band
Pull
(Caution) 1. Fix the cable clip band following the attaching procedure as shown in the figure.
2. To remove the cable clip band, push the cable clip band until it comes off while pressing
the hook of the band following the removing procedure as shown in the figure.
!2
!4
Pull
[ Connection of the connector for CP panel ]
Exclusive connectors are prepared for connection of
the connector for CP-160.
Paying attention to the orientation of the connector
!2 , connect it to connector !3 located on the circuit
board. After connecting, securely lock the connector.
9) After inserting the connector, put all cords together
with cable clip band !4 located on the side of the
box.
(Caution)
1. Fix the cord clamp and the cable clip band
following the attaching procedure.
2. When removing the cable clip band,
remove it while pressing the hook of the
cable clip band.
How to remove cable clip band
Push
Push
Pushing the hook portion, push the band to remove it.
6
Push
Push the hook.