JUKI DDL-8700 Instruction Manual page 10

[ For CE specifications only ]
2
Crimp style terminal section
4
5
1
4
3
b
8
1) Remove three screws 1 located on the side of the
control box.
2) Set power source cover installing plate 2 supplied
with the unit as accessories to the control box main
unit with the three screws which have been
removed.
3) Remove nut section 4 from cord bush 3 supplied
with the unit as accessories.
4) After checking the direction of the nut, pass the
nut through the power source cord supplied with
the unit as accessories.
(Caution) Note that the flat face of the nut should
face the power source cover installing plate
side.
5) Pass the terminal of the power source cord through
the hole from the inside of the power source cover
installing plate.
6) Pass the cord bush, while paying attention to the
direction, through the power source cord from the
power source cord terminal side.
7) Insert connector 5 of the power source cord to
the connector (top) of the control box.
(Caution) Securely insert the connector while
paying attention to the direction.
8) Tighten nut 4 and securely fix the cord bush to the
installing plate.
9) Clamp section b of the cord bush and securely fix
it to the cord.