Connecting The Cords - JUKI DDL-8700 Instruction Manual

6. Connecting the cords

WARNING :
• To prevent personal injury caused by abrupt start of the sewing machine, carry out the work after
turning OFF the power switch and a lapse of 5 minutes or more.
• To prevent damage of device caused by maloperation and wrong specifications, be sure to connect
all the corresponding connectors to the specified places.
• To prevent personal injury caused by maloperation, be sure to lock the connector with lock.
• As for the details of handling respective devices, read carefully the Instruction Manuals supplied
with the devices before handling the devices.
Following connectors are prepared when loosening the front cover fixing screws A of SC-500 and opening the
cover. Connect the machine head connectors to the positions corresponding to each other so as to fit the
devices mounted on the machine head.
A
1 CN30
Motor signal connector
2 CN32
Machine head connector
3 CN33
Needle bar position detector connector
4 CN36
Machine head solenoid connector
5 CN37
Presser foot lifter solenoid connector
6 CN38
CP-160 panel connector
7 CN39
Standing machine pedal connector
8 CN40
Signal for extension connector (For the details, refer to Engineer's Manual.)
9 CN51
Not used
!0 CN52
Not used
!1 CN53
Bobbin thread remaining amount detection solenoid connector
!2 CN189
External interface signal connector
!3 CN59
Bobbin thread count-up output connector
!4 CN55
Material end detection sensor (ED) connector
!5 CN58
Standing machine pedal connector
!6 CN57
Bobbin thread remaining amount detection sensor connector
Front cover
1
2
4
5
OPC circuit board A (asm.)
!0
A
9
3
6
4
!1
!2
!3
!4
!5
!6
7
8