Product Specifications For Hzl-E61 - JUKI HZL-E61 Service Manual

[1] PRODUCT SPECIFICATIONS FOR HZL-E61

[Power source]
[Power consumption]
[Dimensions and weight]
[Speed control]
[Stop position]
[Zigzag width]
[Feed amount]
• 220-230V AC common to 50/60 Hz
• 120V AC common to 60 Hz
• 85W (230VAC), Lamp : 240V/15W
• 1A (120VAC), Lamp : 120V/15W
• Dimensions : Main unit : 410 mm (W) X 180 mm (L) X 300 mm (H)
Case set : 440 mm (W) X 215 mm (L) X 305 mm (H)
• Weight : Main unit : 7.3 kg
Case set : 8.4 kg
• Slide speed control
Straight stitching 115 to 900 rpm
Pattern sewing
Bobbin winding
Reverse stitching 115±10 rpm (at low speed)
• Controller
The slide speed control is effective even when the controller is used.
It is possible to stop the machine only when the stop button is used.
Number of revolutions is the same as the slide speed control above.
• Safety control
If the sewing machine motor shaft is locked, the power supplied to the
motor is stopped after approximately 1.0 to 1.5 seconds.
If the motor becomes extraordinarily hot, the thermal switch built in the
motor stops the power supplied to the motor. It is possible for the motor to
start again after natural cooling.
The machine stops with its needle down when sewing is completed.
• The machine stops with its needle down except buttonholing.
• The needle moves up when it is in down position and a pattern
is selected.
• The machine stops with its needle up when the reverse
stitching is completed.
• The machine stops with its needle up when the bobbin is to be
wound.
• The machine stops with its needle up when the machine starts
with the presser lifting lever raised.
• Max. 7 mm depending on the patterns.
When zigzag width is changed with the manual lever, buzzer
sounds at the place where zigzag width is changed.
• Feed amount changes in increments of 0.2 mm by the variable
resistor for manual adjustment.
When feed amount is changed with the manual lever, buzzer
sounds at the place where feed amount is changed over.
2.4 mm for straight stitching when the feed is set to "Auto".
-1- -1- -1- -1- -1-
115 to 750 rpm
115 to 900 rpm