1] Specifications Of Hzl-G Series - JUKI HZL-G Series Service Manual

[1] Specifications of HZL-G Series

(1) Power switch
･ 220-240V AC common to 50/60 Hz
･ 20V AC common to 60 Hz
(2) Power consumption
･ 65 W
(3) Dimensions and weight
･ Dimensions
･ Weight
(4) Revolution control
･ Slide style speed control
Straight stitch
Pattern stitch
Reverse stitch
Bobbin winding 500 〜 3000 sti/min (RPM)
Low-speed start 80 〜 0 sti/min (SPM) (approx.  second only when the power switch is turned ON）
･ Foot controller
Even when the foot controller is used, the speed control function by means of the slider is effective.
To stop the machine, either release the foot controller or press start/stop button.
The number of revolutions is controlled in the way same with the case of the slide speed control.
Thread trimming switch (Press heel side of foot controller.)
･ Safety control
When the motor shaft of the sewing machine is accidentally constrained, the power supply to the
motor is stopped within two seconds.
When the motor is overheated, the built in thermal switch stops the power to the motor.
Note that the machine can be restarted once the motor spontaneously cools down.
(5) Stop position
･ Upon finishing sewing, the machine stops according to the preset needle stop position (with its needle up or
down).
･ Upon finishing reverse stitching, the machine stops with its needle down.
･ In the case the machine is started with the presser foot lifting lever raised, the machine stops with its needle
up.
･ Needle moves down when the machine has preset so that the needle stops at its up position and needle up/
down button is pressed.
･ Needle moves up when the machine has preset so that the needle stops at its down position and needle up/
down button is pressed.
･ In the case of fault, the machine stops immediately (stop position varies).
(6) Zigzag width
・ Max. 7 mm depending on the pattern selected
Main unit: 445 (width) x 20 (depth) x 290.5 (height) (mm)
Case set: 50 (width) x 257 (depth) x 305 (height) (mm)
Main unit: G20 9.4 kg
80 〜 900 sti/min (SPM)
80 〜 750 sti/min (SPM)
80 〜 0 sti/min (SPM)
80 〜 900 sti/min (SPM) (when the speed controller is used）
G0 8.9 kg
–  –