Figure 4-13 Processor Slot Locations on the Processor Extender Board
Removing a Processor
To remove a processor on the processor extender board, follow these steps:
NOTE:
The processor being removed in this procedure is CPU 1. This procedure applies to all
the processors on the processor extender board.
1.
If rack mounted, slide the server out from the rack until it stops. See
From the Rack" (page
2.
Remove the front bezel. See
3.
Remove the front cover. See
4.
Remove the processor extender board. See
(page
43).
5.
Using a torx T15 driver, loosen the six captive T15 shoulder screws that attach the sequencer
frame on the heatsink in the order specified in
46
Removing and Replacing Components
31).
"Removing the Front Bezel" (page
"Removing the Front Cover" (page
"Removing the Processor Extender Board"
34).
35).
Figure 4-14
until the sequencer frame is free.
"Extending the Server