Removing The Top Cover; Replacing The Top Cover; Removing And Replacing The Top Cover - HP Integrity rx4640 Service Manual

Removing the Top Cover

To remove the top cover, follow these steps:
1. If rack mounted, slide the HP server out from the rack until it stops. See
Server From the Rack" (page
Figure 4-5 Removing and Replacing the Top Cover
2. Loosen the two captive thumbscrews that hold the top cover in place.
3. To free the tabs from the slots in the chassis, lift the cover straight up and pull it toward the
rear of the server.

Replacing the Top Cover

To replace the top cover, follow these steps:
1. Align the tabs at the rear of the top cover with the corresponding slots in the chassis, fully
seat the tabs into the slots, and push forward until it seats.
2. Using a torx T15 driver, tighten the two thumbscrews securely.
3. If rack mounted, slide the server into the rack until it stops. See
the Rack" (page
36 Removing and Replacing Components
31).
32).
"Extending the
"Inserting the Server into