Hp Ups Power Protection Agent Overview; Hp Ups Power Protection Agent Requirements - HP UPS User Manual

HP UPS Power Protection Agent overview

The HP UPS Power Protection Agent runs on a local or network server and allows the management
module to gracefully shut down the operating system of that server and optionally run a script during
power failure. Install the agent on any machine that is powered by the UPS and any machine that the
management module uses to initiate a command.
NOTE:
Agent before installing the UPS Power Protection Agent.
If the UPS Power Protection Agent is not applicable for your load devices, you can use a third-party
SNMP manager to monitor the power protection. For more information, see "SNMP monitoring (on page
116)."

HP UPS Power Protection Agent requirements

NOTE:
(http://www.hp.com/go/rackandpower).
Hardware and software
Hardware
Disk space
System memory
Operating system (32-bit)
If you are an existing HP Power Manager user, you must uninstall the HPPM Remote
For the latest supported operating systems, see the HP website
Suggested minimum requirements
200-MHz processor
10 MB free disk space
64 MB of RAM
Microsoft® Windows Server® 2008 R1 Standard, Enterprise, and Datacenter
Editions
Microsoft® Windows Server® 2003 R2 Standard and Enterprise Editions
Microsoft® Windows Server® 2003 R1 Standard and Enterprise Editions
Microsoft® Windows® Small Business Server 2003, Standard and Premium
Editions x86 R2 with Service Pack 2
Microsoft® Windows Server® 2003 Standard and Enterprise Editions x86 R2
with Service Pack 1
Microsoft® Windows® 7 Enterprise
Microsoft® Windows® XP Professional with Service Pack 3
Microsoft® Windows® Vista Professional with Service Pack 2
Red Hat Enterprise Linux 5 for x86 with Update 3
SUSE Linux Enterprise Server 11 for x86
SUSE Linux Enterprise Server 10 for x86 with Service Pack 3
VMware ESX Server 3.5.5 U5¹
VMware ESX Server 4.0 U1¹
VMware ESX Server 3.5.0¹
Overview 8