Hp Ups Management Module Service Menu; Hp Ups Management Module Service Menu Overview; Accessing The Service Menu; Telnet Session - HP UPS User Manual

HP UPS Management Module Service Menu

HP UPS Management Module Service Menu
overview
The HP UPS Management Module Service Menu provides an alternative, limited interface to the
management module when the web interface is disabled or not preferred. The menu structure textually
displays various measurements and warning and alarm messages from the management module. Also,
system values and power fail settings can be configured through the Service Menu and sent to the
management module.
NOTE:
Management Module Service Menu are available using the HP UPS Management Module
web interface (on page 42).

Accessing the Service Menu

You can access the Service Menu:
•
Remotely through a telnet session (on page 82)
•
Locally through a terminal emulation session (on page 83) using an available serial port

Telnet session

Use a telnet session to access the HP UPS Management Module Service Menu:
If necessary, configure the management module:
1.
Launch a terminal emulation program
a.
Configure the management module remote access settings
b.
module for remote
Be sure that you have connected the network cable
2.
the management module.
Launch telnet by entering the following command at a DOS prompt or the command line:
3.
Telnet xxx.xxx.xxx.xxx
where xxx.xxx.xxx.xxx is the IP address of the management module.
At the prompt, enter the user name and password. The default user name is admin, and the default
4.
password is admin.
For more information about the Service Menu, see "Service Menu (on page 84)."
All status information and configuration parameters included in the HP UPS
access" on page 22).
("Launching a terminal emulation
("Configuring the management
("Connecting the network
HP UPS Management Module Service Menu 82
program" on page 21).
cable" on page 20) to