Configuring The Management Module For Remote Access - HP UPS User Manual

On the host computer, click Start, and select
1.
Programs>Accessories>Communications>HyperTerminal.
The Connection Description window appears.
Enter a description, select an icon for the connection, and then click OK. The Connect To window
2.
appears.
Select the serial connector on the host computer to which the DB-9 to RJ-45 adapter is attached, and
3.
then click OK. The COM Properties window appears.
Select the following parameter values, and then click OK.
4.
Bits per second—115200
o
Data bits—8
o
Parity—None
o
Stop bits—1
o
Flow control—None
o
Configuring the management module for remote
access
Be sure that you have connected the network cable
1.
the management module.
Be sure that you have connected the configuration cable
2.
page 21) to the management module and the host computer with an open terminal emulation
session.
Press the Reset button on the management module front panel.
3.
On the terminal emulation session screen running on the host computer, the POST executes, and the
following prompt appears:
Press any key in 5 seconds to enter Service menu.
Press a key to enter the HP UPS Management Module Service Menu.
4.
("Connecting the network
("Connecting the configuration
Installing the HP UPS Management Module 22
cable" on page 20) to
cable" on