Table of Contents
Advertisement
noft Diagnostic Messages
*** SYNTAX ERROR *** [3025]:
No symbol table available, command ignored.
Cause. This error occurs for various undocumented commands. It indicates that either
a SET SCOPESOURCE command or SET SCOPEPROC command was given, but there
was no symbol table.
Recovery. Either use
on page 5-42 to change the scope, or recompile the program with symbol information.
To see the current scope, use
*** SYNTAX ERROR *** [3026]:
No unresolved references in procedure-name, command ignored.
Cause. This error occurs for the undocumented GINFOSITE and GINFOUNRES
commands. It indicates that nothing was in the scope.
Recovery. Either use
SET
on page 5-42 to change the scope. To see the current scope, use
page 5-47.
*** SYNTAX ERROR *** [3027]:
Obey requires filename, command ignored.
Cause. The filename specified in the
Recovery. Change the filename to that of an obey file.
*** SYNTAX ERROR *** [3028]:
Offset out of range for [procedure|object file].
Cause. If the message refers to a procedure, the scope set for dumping does not
include the specified range. If the message refers to an object file, the object file does
not contain the addresses or offsets specified.
Recovery. If the message refers to a procedure, ensure that the desired range falls
within the procedure. Use SET SCOPEPROC * to turn scoping off (see
page 5-42). Use
on page 5-10. If the message refers to an object file, ensure that the addresses or
offsets are possible.
RESET
on page 5-41 to reset the scope to its default, use
SHOW
RESET
on page 5-41 to reset the scope to its default or use
DUMPADDRESS or DA
nld and noft Manual—520384-003
on page 5-47.
OBEY
on page 5-39 is not an obey file.
on page 5-6 instead of
11 -27
Syntax Errors
SET
SHOW
on
SET
on
DUMPPROC or DP
Advertisement
Table of Contents
