Raymarine Raynav 300 GPS Plotter Owner's Handbook Manual page 54

3-26
4. Press the MAKE ROUTE soft key; the make route soft keys are dis-
PLACE
WAYPOINT
5. Move the cursor to the position on the plotter where the first waypoint
Note: The cursor can be positioned on an existing waypoint - the text
WPT indicates that the existing waypoint is being re-used rather than
placing a new one. Press PLACE WAYPOINT to include this waypoint in the
route. If you Clear the route before it is Saved, the waypoint is removed.
6. Move the cursor to the next waypoint position. A dotted line connects
7. Press PLACE WAYPOINT again. The waypoint is placed and the dotted
8. Repeat steps (6) and (7) until you have placed all your waypoints. Up
9. To remove a waypoint move the cursor over it and press UNDO WAY-
10. When all waypoints have been entered, press the ACCEPT ROUTE soft
➤
To use a combination of the Cursor and Route Building Table methods,
alternate between them using the USE CURSOR/USE WPT LIST soft key.
When in the plotter screen, the first waypoint of a new route is outlined
with a square, indicating that it will be the target waypoint when the route
is activated. If selected, the waypoint data box is displayed for the target
waypoint.
played as shown in Figure 3-31.
UNDO
WAYPOINT
Figure 3-31: Make Route Soft Keys
is to be placed, then press the PLACE WAYPOINT soft key; the new
waypoint appears on the screen at the cursor position.
A new waypoint is temporarily added to the Waypoint List with the
first available waypoint number. The waypoints in the current route
are re-numbered to identify the new positions. The number shown
adjacent to the waypoint identifies its position in the route.
the cursor to the last placed waypoint.
line changes to a solid line.
If you placed the waypoint incorrectly, you can delete the last-placed
waypoint by pressing the UNDO WAYPOINT soft key.
to 50 waypoints can be included in a route.
POINT; the waypoint is removed and the cursor is placed over the pre-
vious waypoint.
key (or ENTER) to complete the route.
The new route is displayed on the screen and becomes the current
route, but it is not yet active.
Raynav 300 GPS Plotter
ACCEPT USE WPT
ROUTE LIST
D4928-1