Initial Switch On; Checking The Plotter Operation - Raymarine Raynav 300 GPS Plotter Owner's Handbook Manual

Chapter 5: Installation

Initial Switch On

To switch on the plotter:
1. Press and hold the POWER key until the unit beeps.
2. If necessary, adjust the lighting and contrast (see Chapter 2).
3. If required, change the default language settings as follows:
DATA BOXES
BEARING MODE
CURSOR DISPLAY
CURSOR READOUT
DAY/NIGHT
HELP
4. Using trackpad up/down, select the LANGUAGE option.
5. Using left/right soft key arrows, select the required language.
6. Press ENTER to return to the setup soft keys, then CLEAR to return to

Checking the Plotter Operation

To confirm that your Plotter is operating correctly, perform the following
checks:
1. Check that appropriate GPS data is displayed.
2. Press the DISPLAY key until the plotter screen is displayed. Press the
3. Ensure that position data is available; use the FIND SHIP function to
i. Press the MENU key to display the setup function bar.
ii. Press the SYSTEM SET UP soft key and press ENTER.
The SYSTEM SET UP menu is displayed, listing the parameters and
their current settings. The complete list, which can be scrolled
through, is shown in part in Figure 5-7:
SYSTEM SET UP MENU
Figure 5-7: System Set Up Screen
the normal Plotter screen.
trackpad left/right, up/down and check cursor movement and normal
scrolling action.
check that the cursor is fixed on the vessel symbol which is correctly
positioned at the centre of the Plotter display, see Chapter 4: Setting
Up the GPS Plotter.
TRUE
RELATIVE
RNG/BRG
DAY
ON
5-15
D4949-1