Placing A Waypoint - Raymarine Raynav 300 GPS Plotter Owner's Handbook Manual

Chapter 3: Operation
At the end is a section about using the ST60/80 Navigator Keypad to
select, edit and name your waypoints.

Placing a Waypoint

➤
To access the Place Waypoint soft keys, press MARK; the Place
Waypoint soft keys are displayed as shown in Figure 3-17:
PLACE WPT
AT CURSOR
➤
To place a waypoint at the cursor (plotter screen) or the vessel's current
position:
1. Press either the PLACE WPT AT CURSOR or the PLACE WPT AT VESSEL
2. Press CLEAR to remove the Place Waypoint soft keys.
➤
To place a waypoint as a latitude/longitude position using the Waypoint
List:
1. Press MARK, followed by the WAYPOINT LIST soft key; the Waypoint
WAYPOINT
PLACE WPT
AT VESSEL
Figure 3-17: Waypoint Soft Keys
soft key. The waypoint is added to the Waypoint List and tagged using
the next available number.
If you place a waypoint at the cursor, the Waypoint soft keys shown
in Figure 3-23 are shown. Press CLEAR to remove these softkeys.
List and associated soft keys are displayed as shown in Figure 3-18:
WAYPOINT LIST
SYMBOL
POSITION
BRG 348°m
TEMP 20°C
DATE 23/11/01
GOTO EDIT
WAYPOINT
Figure 3-18: Waypoint List and Soft Keys
The list details all waypoints in alpha-numerical order. The selected
waypoint is indicated by the highlight bar; its position in Lat/Long,
WAYPOINT
LIST
NAME
WPT 001
WPT 002
WPT 003
WPT 004
N 50°50^000
W 001°06^000
RNG 1.00nm
DEPTH 12.3m
TIME 08:45:12
MAKE NEW WAYPOINT
WAYPOINT TRANSFER
3-13
D4905-1
D4906-2