Panel Mounting - Raymarine Raynav 300 GPS Plotter Owner's Handbook Manual

Chapter 5: Installation
4. Secure the gasket to the rear of the unit:
5. Fit the unit to the trunnion, adjust the display angle and tighten the
6. Connect the Power/NMEA and GPS cables to the unit, avoiding tight

Panel Mounting

CAUTION:
Make sure that there are no hidden electrical wires or other items
behind the location before proceeding. Make sure that there is
sufficient rear access for mounting and cabling.
The unit can be panel mounted, using the panel-mounting kit (accessory)
available from your local Raymarine dealer.
➤
Referring to Figure 5-5, panel mount the unit as follows:
1. Check the selected location for the unit. A clear, flat area at least
2. Unpack the (optional) panel-mounting kit.
3. Using the supplied template, trace out the display unit cut-out and
4. To provide start holes for removing the cut-out, drill four
5. Drill out the four
6. Using a suitable saw, cut along the inside edge of the cut-out line.
7. Remove the trunnion (yoke) knobs and carefully pry off the (black)
8. Offer up the unit to the cut-out ensuring that it fits in the cut-out area.
9. Offer up the gasket to the unit ensuring that it lines up with the brass
Note: The gasket must be fitted to ensure EMC compliance.
10. Remove the protective paper from the adhesive side of the gasket
11. Press the gasket onto the unit and slide the unit into the panel cut-out.
Remove the protective paper from the adhesive side of the gasket
(this is the side that is to be affixed to the unit) then press the gasket
onto the rear case, covering the screws.
knobs.
bends in the cables.
7.67in (195mm) wide by 4.33in (110mm) high, with at least 5in
(125mm) of clearance behind the panel, is required.
mark the drilling centers for the four securing holes outside of the
cut-out area.
(10mm) holes in each opposing corner of the cut-out area.
/
3
plate. It is recommended that a
ratchet inserts from the unit case.
inserts in the case.
(this is the side that is to be affixed to the unit).
in (5mm) securing holes as indicated on the tem-
16
/ in (1mm) pilot hole is drilled first.
1
16
5-9
/ in
3
8