Customizing The Display Options - Raymarine Raynav 300 GPS Plotter Owner's Handbook Manual

2-8
6nm
➤
To change the scale rapidly, press and hold top or bottom of the RANGE
key.
The distance indicator at the left-hand side of the status bar is updated
whenever you change the display scale.
➤
To zoom in to a larger-scale (more detailed) display:
1. Use the trackpad to position the cursor in the area you wish to see in
2. Press the bottom of the RANGE key to zoom into the area.
➤
To zoom out to a smaller-scale (less detailed) display, press the top of the
RANGE key as many times as required, up to the maximum scale of
1200nm.

Customizing the Display Options

The SCREEN soft key enables the following screen display options to be
set on or off:
•
•
•
The factory default for these options is ON.
Switching the Cursor Data Box On/off
The cursor data box provides the cursor's position in latitude/longitude
and/or bearing/range.To see a full image, switch the data box off.
➤
To control the cursor data box:
1. Press the SCREEN soft key.
2. Press the CRSR BOX soft key to toggle the setting between ON and OFF.
To return to the default soft key display, press CLEAR.
➤
To move the cursor box:
1. Use the trackpad to position the cursor over the box until the letters
2. Press ENTER to take control of the box, use the trackpad to move it to
VES
POS 001°02^83W
Figure 2-6: Status Bar
larger scale.
The display, centered on the cursor, is enlarged to show a larger scale
and the distance indicated in the status bar is updated.
Cursor Box (CRSR BOX)
Grid (GRID)
Personalized (CUSTOM)
BOX are displayed.
the required position and press ENTER again.
43°27^05N
Raynav 300 GPS Plotter
SOG 23.4kts
COG 234°M
D4902-1