Data Log - Raymarine Raynav 300 GPS Plotter Owner's Handbook Manual

Chapter 3: Operation

Data Log

The GPS Plotter can be set to log passage data every 30 minutes. Up to 48
log entries are held. When 48 entries have been saved, the first entries
start being overwritten.
If the number of log entries exceeds the table size, use the trackpad
up/down to scroll the list and view further log entries. Each line in the log
shows:
•
•
•
•
You can stop the log at any time and you can clear the log from memory.
➤
To use Data Log Mode:
1. Press DISPLAY repeatedly until the Data Log table is displayed.
2. Press the START LOG soft key to start logging; the START LOG soft key
At 30 minute intervals, the current time, vessel's position, distance made
good (DMG) and course made good (CMG) are recorded as shown in
Figure 3-16.
TIME
09:00
20/12
09:30
20/12
10:00
20/12
ROUTE
3. Press the STOP LOG soft key to stop logging.
4. Press the CLEAR LOG soft key to clear all log entries.
Time of log entry
Position at time of log entry
Course Made Good (CMG) since last log entry
Distance Made Good (DMG) since last log entry
changes to STOP LOG.
POSITION
50°50^000N
001°06^000W
50°51^000N
001°07^000W
50°52^000N
001°08^000W
GOTO
Figure 3-16: Data Log Screen
CMG DMG
239°m 4.8nm
241°m 5.2nm
240°m 4.5nm
STOP LOG CLEAR LOG
3-11
D4924-1