Quadra-Fire CASTILEI-MBK Owner's Manual page 23

R
H. Surround and Cast Trim Set (Cont'd)
(4) Felt Vibration Insulation Pads
Secure
Surrounds to
Cast Trim Kit
Attach Magnet
before installing
Cast Footers
Magnet Installed
Figure 23.1
Back
of
Side
Piece
Magnet Attached - Faces Front
Figure 23.2
Surround Set
attaches to top
and bottom of
insert sides.
Figure 23.4
January 19, 2011
Cast Footers,
Left & Right
Clearance Notch
Figure 23.3
Thumb
Screw
I. Optional Log Set Placement Instructions
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
Two Piece Log Set Installation
1. Open door to expose the fi rebox.
Install the left log fi rst and then the right log. Figure 23.1
2.
3. Lean the logs against the cast iron brick in the back of
the fi rebox.
4. Push the logs to the far left and far right against the
sides of the fi rebox. Figure 23.2.
5. To clean the logs, use a vaccum cleaner and a soft
brush attachment or a paint brush.
Figure 23.5
Bracket
Figure 23.6
NOTE:
Due to the abrasive nature of a pellet appliance fi re, the
logs are not covered under warranty. Any placement vari-
ation other than shown here can cause excessive heat
and shall void the appliance warranty.
7022-122
Castile Pellet Insert
CAUTION
Page 23