Assemble Leg Curl Seat - Precor move beyond S3.25 Assembly And Maintenance Manual

S3.25 Assembly and Maintenance Guide

6. Assemble Leg Curl Seat

A. Attach the Backpad Support Tubes to the Seat
Upright using
one 5½-inch bolt
two ½-inch washers
one ½-inch locknut
Note: The tube with the Selector Pivot Flat is
nearest the Weight Stack. Also, the hole in the
other support tube is positioned closest to the
Backpad Pop Pin, as shown.
Wrench tighten, and then loosen until the support
tube can fall freely without wobbling.
CAUTION: Keep your hands clear to avoid
injury when the support tube falls.
B. Align the Selector Pivot Flat with the Backpad Pop Pin.
C. Attach the Seat Pad to the Seat Upright using
one 7-inch bolt
one ½-inch locknut
Finger tighten.
Step 6. Assemble Leg Curl Seat
Backpad Support
Tubes
Selector
Pivot Flat
Backpad
B
Pop Pin
A
Seat Upright
1 2
Seat Upright
1 - 5½" bolt
2 - ½" washers
1 - ½" locknut
3 4
Seat Pad
1 - 7" bolt
C
1 - ½" locknut
5 6
page 15