Fujitsu M4097D Operator's Manual page 19

Button/LED Function
Name of the button and
LED
Button Next
Previous
Exit
Enter
Send To/
Start
Stop
LED
Read
Check
1-6
Function
Displays the next LCD screen.
Displays the previous LCD screen.
Moves the cursor to the left.
Moves the cursor to the right.
When you are entering settings on the Operator panel, pressing this button
returns you immediately to the"Scanner Ready" screen.
Enters the parameter currently selected by the cursor.
Operational only when Manual start mode is set or the"Read" lamp lights;
Starts the reading when video interface option is used. Some application
software packages make use of this button.
When the "Check" LED lights, pressing this button releases the error status
(turns off "Check" and returns to the "Scanner Ready" screen).
Operational only during the reading operation; stops the reading when the
video interface option is used.
Also turns off the "Check" lamp.
Indicates that the scanner is On.
Indicates the scanner is reading or ready to read.
If lit, this indicates that an alarm occurred. Pressing the"Stop" button
turns the "Check" lamp Off.
If it blinks at one second intervals, this means that a jam or double feed
has been detected. If the problem is jammed paper, removing the jammed
paper turns off the "Check" lamp. If the problem is double feed, pressing
the "Stop" button turns off the"Check" lamp.
If it blinks at four seconds intervals, this means that cleaning the ADF is
necessary.