Installation Instructions For Internal Drain Kit (Idk) - Friedrich WallMaster WS08C10 Service Manual

1. DRILL A .625" DIAMETER HOLE IN THE BOTTOM OF THE SLEEVE BASE TO THE
DIMENSIONS SHOWN.
2. APPLY A SILICONE TYPE OF SEALER TO THE OUTSIDE BOTTOM EDGES OF THE
DRAIN PLATE.
3. INSERT THE DRAIN TUBE INTO THE HOLE AND PRESS THE DRAIN PLATE DOWN TO
FORM A WATERTIGHT SEAL AGAINST THE SLEEVE BASE.
4. DRILL A .625" DIAMETER HOLE IN THE BOTTOM OF THE BASE PAN AS SHOWN IN THE
ILLUSTRATION. THIS HOLE ALLOWS CONDENSATE TO ENTER THE WALL SLEEVE
WHERE IT TRAVELS TO THE DRAIN KIT FOR DISPOSAL.
50
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
FOR INTERNAL DRAIN KIT
FOR INTERNAL DRAIN KIT (IDK)
Wall Sleeve
Drill a .625"
diameter
hole here
Sleeve
Base
Sharp edges and corners. Be careful with
Be careful with the sharp edges and corners.
the sharp edges and corner. Wear protective
Wear protective clothing and gloves, etc.
clothing and gloves, etc.
Failure to do so could result in serious injury.
Failure to do so could result in serious injury.
(IDK)
Apply Sealer to
the bottom of
the Drain Plate
Dimple
WARNING
WARNING
MECHANICAL HAZARD
MECHANICAL HAZARD
CUT/SEVER HAZARD
0.5" In
from edge
4.75" From
back of
Drill a .625"
basepan
diameter
hole in the
bottom of
the basepan