Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
STEP 1
Before sliding chassis into outer shell, turn chassis on its side and add drain hole by drilling ½"
diameter hole as shown in Figure 1.
STEP 2
DC-2 mounts to the bottom of the outer shell as shown in Figure 2 on the right side as you
face the unit. Use two (2) 10 - 24 x 3/8" long machine screws and 10 - 24 hex nuts provided.
STEP 3
SQ, KQ, YQ Models - Drill two ¼" holes in outer shell as shown in Figure 3. Also drill a 3/8"
diameter hole in the base pan 3½" from the back and 3½" from right side.
STEP 4
Small and Medium Chassis Models - Mount in second and third holes from the rear of shell;
See Figure 4.
STEP 5
Large Chassis Models - Mount in third and fourth holes from the rear of shell; see Figure 5.
STEP 6
Connect a suitable length of garden hose or other tubing to end of the drain tube to drain the
condensate away.
TTJ-0197 (1/97)
FOR DC-2 DRAIN KIT
(Page 15 of 64)
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
