Installation Instructions For Dc-2 Drain Kit - Friedrich KQ08J50A-B Service & Parts Manual

INSTALLATION INSTRUCTIONS FOR DC-2 DRAIN KIT

STEP 1 Before sliding the chassis into the outer shell, turn the chassis on its side and add a drain hole by drilling a
1/2" diameter hole as shown in Figure 1.
STEP 2 DC-2 mounts to the bottom of the outer shell as shown in Figure 2 on the right side as you face the unit. Use
two (2) 10-24 x 3/8" long machine screws and 10-24 hex nuts provided.
STEP 3 SQ, KQ, YQ Models - Drill two 1/4" holes in the outer shell as shown in Figure 3. Also drill a 3/8" diameter
hole in the base pan 3 1/2" from the back and 3 1/2" from the right side.
STEP 4 Small and Medium Chassis Models - Mount in the second and third holes from the rear of the shell. (See
Figure 4.)
STEP 5 Large Chassis Models - Mount in the third and fourth holes from the rear of the shell. (See Figure 5.)
STEP 6
Connect a suitable length of garden hose or other tubing to the end of the drain tube to drain the condensate
away.
FIGURE 1
BACK OF BASE PAN
FIGURE 3
2"
"SQ," "KQ," "YQ" MODELS
BOTTOM VIEW
RIGHT SIDE
APPROXIMATE
LOCATION OF EM-
BOSSMENT. DRILL
1/2 " DIA. HOLE.
FIGURE 4
3rd AND 4th HOLES
6"
FROM REAR OF
3/8"
SHELL
SMALL AND MEDIUM
CHASSIS MODELS
FIGURE 2
FIGURE 5
3rd AND 4th HOLES
FROM REAR OF
SHELL
LARGE CHASSIS MODELS
10–24 x 3/8" LONG
SCREWS
DRAIN PLATE
10–24 NUTS
BOTTOM VIEW
Page 7