Preparing The Mower For Storage - Hayter Harrier 56 340S Owner's Handbook Manual

PREPARING THE MOWER FOR STORAGE

1.35
1.35
PREPARING THE MOWER FOR STORAGE
Handlebar storage: To lower the handlebar unscrew the 2 secur-
ing knobs sufficiently to allow it to be pivoted forwards to rest
against the mower. Take care to ensure that the control cables do
not become snagged at the pivot point and depress the engine stop
lever to prevent it being damaged through contact with the engine
spark plug.
Storage for periods in excess of 30 days: Engines stored in
CS082
excess of 30 days need to be protected with Briggs & Stratton fuel
additive or drained of fuel to prevent gum from forming in the fuel
system or on essential carburettor parts. To ensure your mower is
maintained in good working order it is important that the follow-
ing procedure is adopted. Refer to the Maintenance section as
necessary.
Drain fuel from the engine by operating the engine until it stops.
Disconnect the spark plug lead.
Change the engine oil.
Remove the engine spark plug and pour 15ml of engine oil into the engine cylinder and
replace the spark plug. Do not exceed the stated volume of oil as engine damage may occur
on re-starting. Do not replace the spark plug lead. Slowly pull the engine start - grip once
to crank the engine. This will distribute the oil and help prevent engine corrosion.
Clean grass and debris from the engine cylinder, cylinder head cooling fins, under top cowl,
and around and behind muffler/muffler guard.
Clean all other areas of the mower and ensure that the grassbag is clean.
Charge the battery (Electric start models only)
Lubricate the mower.
Treat metal parts with a water repellent anti-corrosion product.
Lower the handlebar, if desired.
Disconnect the battery leads (electric start models only).
Rest the mower deck on wooden blocks to remove the mower from its wheels / roller.
Cover the mower with a protective sheet and store it in a dry, ventilated area.
340222MT270999A