Table of Contents
Advertisement
Taking Still Pictures
Power switch
Shutter release button
Zoom/$$$/$
button
The standard procedure for taking still pictures is described below. The
flash fires automatically depending on the light conditions.
1
Press the power
switch.
The camera turns on and is ready to take
still pictures. In this manual, this is called
Still Picture Capture Mode.
2
Confirm
the subject
and shooting
information
on the LCD monitor.
The focus frame in the middle of the LCD
monitor indicates the zone of automatic
focusing.
You can change the captured area by pressing the Zoom/_$/$
button
to the left or right.
$ : enlarges the subject
_, : widens the area that is captured by the camera
3
Press the shutter
release
button
halfway.
The focus frame on the LCD monitor turns green if the subject is in focus.
4
Press the shutter
release
button fully.
The picture is taken.
The image appears on the LCD monitor for one second (Instant Review)
and is saved to the SD Memory Card or built-in memory. (p.25)
Focus frame
Advertisement
Table of Contents
