Table of Contents
Advertisement
Problem
i
Cause
.
Remedy
Lock focus on another object located at
Subject
is not in
focus
Flash does not
discharge
USB connection
with computer
does not work
properly
USB connection
with printer does
not work properly
Subject
is difficult
to
focus on with
autofocus
Subject
is not in
focusing
area
Flash mode is setto
(Flash
Off)
Drive mode is set to _[_
Focus mode is set to
,A
Shooting
mode is set
to _'
USB connection
mode
is set to [PictBridge]
USB connection
mode
is set to [PC]
same
distance
(press
shutter
release
button
halfway),
then aim at target and
)ress shutter
release
button
fully (p.39),
or use Manual
Focus
mode.
(p.79)
Position subject in focus frame in middle of
LCD monitor. If the subject is outside the
focusing area, aim the camera at the subject
and lock the focus (press shutter release
button halfway), then compose picture and
)ress the shutter release button fully.
Set to Auto or _- (Flash
On). (p.80)
Flash will not discharge
in these
modes.
Change
the USB connection
mode to
[PC]. (p.155)
Change the USB connection mode to
[PictBridge]. (p.136)
iiiiiiiiiiiiiiiiiiiiiiiiii
Static electricity
may occasionally
preventthe
camera
from operating
correctly.
If this
should
occur,
try removing
and then reloading
the battery.
If the camera
turns on and
operatesproperly,
thisindicatesthatthereisnomalfunction.
Youcanusethecamera
as usual.
Advertisement
Table of Contents
