Table of Contents
Advertisement
I
k0045
I
During the cooling
process,
some water will be extracted
from the air and stored within
the unit's water reservoir.
If the water reservoir
is full, both the compressor
and motor will stop and the unit will
beep (press any button to stop the beeping
sound).
The full water tank indicator
light
will also start flashing.
To resume
cooling,
empty the reservoir
by following
these steps:
1.
Turn off the air conditioner and unplug it
from the wall socket. To prevent water
leakage, avoid moving the unit when full.
2.
Place a container (such as a small pan)
underneath the hole.
,
Remove the rubber plug from the hole
and allow the water to drain out.
4.
When the container is almost full, replace
the plug back into the hole.
5.
Repeat these steps until the water
reservoir is completely empty.
6.
Replace the rubber plug and make sure it
is firmly in place.
7.
Turn the unit back on. The full tank
indicator light should turn off.
Water hole/
Rubber plug/
:_Drain knob
FIG.14
Hide quick links:
Advertisement
Table of Contents
