Draining The Unit - NewAir AC-14100E Owner's Manual

DRAINING THE UNIT

During the cooling process, some water will be extracted from the air and stored within the unit's
water reservoir.
If the water reservoir is full, both the compressor and motor will stop and the unit will beep (press
any button to stop the beeping sound). The full water tank indicator light will also flash.
To resume cooling, empty the water reservoir by following these steps:
1. Turn off the air conditioner and unplug it
from the wall socket. To prevent water
leakage, avoid moving the unit when full.
2. Place a container (such as a small pan)
underneath the drainage port.
3. Remove the water plug from the drainage
port and allow the water to drain out.
4. When the container is almost full, replace
the water plug back into the drainage port
and empty the water container.
5. Repeat until the water reservoir is
completely empty.
6. Replace the water plug back into the
drainage port and make sure it is firmly in
place.
7. Turn the unit back on. The full water tank
indicator should turn off.
To operate the unit continuously without manually emptying the tank, follow these steps:
Remove the water plug from
the drainage port and retain it
for future use.
Connect the included drainage
hose to the drainage port as
shown. Connect the other end
of the hose into a drain.
Rubber plug
11
FIG.20
Drain knob
FIG.21