Draining The Unit - NewAir AC-14100E Owner's Manual

level. Once the ambient temperature rises above the set temperature,
cooling will resume.
•
The heating system will turn off if the ambient temperature is higher than
the set temperature. However, the fan will continue operating at the set
level. Once the ambient temperature drops below the set temperature,
heating will resume.
•
This machine is equipped with an ANTI-FROST function. When using the
heating function in low temperature the heater will occasionally stop
heating in order to melt any frost that has accumulated within the air
conditioner. Normal operation will resume in a few moments.

DRAINING THE UNIT

During the cooling and dehumidifying processes, some water will be extracted
from the air and stored within the unit's water reservoir.
If the water reservoir is full, both the compressor and motor will stop and the
unit will beep (press any button to stop the beeping sound). The full water tank
indictor light will also start flashing.
To resume cooling, first empty the reservoir by following these steps:
1. Turn off the air conditioner and
unplug it from the wall socket. To
prevent water leakage, avoid
moving the unit when full.
2. Place a container (such as a small
pan) underneath the drainage port.
3. Remove the water plug from the
drainage port and allow the water
to drain until the water reservoir is
completely empty.
4. Replace the water plug back into the drainage port and make sure it is
firmly in place.
5. Turn the unit back on. The warning signal should be off.
www.newair.com
EN
21