Table of Contents
Advertisement
TO BE COMPLETED BY THE INSTALLER
Check all parts are installed.
Ensure that all panels and parts thereof are secure and final electrical tests have been
conducted in accordance with local electrical regulations.
Check that the dishwasher is level. If necessary, adjust the levelling feet slightly. To ensure
optimum performance, the dishwasher should not be inclined more than 1
spirit level.
Ensure inlet hose to water supply has supplied rubber washer fitted, and that it's
tightened a further half turn after seal contact.
Ensure any knock-outs or plugs in drain connection have been drilled out and drain
connection has been made.
The drain hose joiner must not support the weight of excess hose material. Keep drain
hose as fully extended as possible to prevent sagging. Any excess length of drain hose
should be kept on the dishwasher side of the highloop.
If connecting the drain hose to the sink trap, ensure the Highloop is a minimum 150mm
higher than the drain hose joiner.
Ensure any packaging or tape securing the racks is removed from the dishwasher.
Ensure product is level and opens and closes freely. The door must be free to fully close
without being obstructed by adjoining cabinetry or the floor.
Complete and keep for safe reference:
Model
Serial No.
Purchase Date
Purchaser
Dealer Address
Installer's Name
Installer's Signature
Installation Company
Installation Date
FINAL CHECKLIST
Check that the door opens and closes freely without resistance to adjacent
cabinetry.
Check that the electrical outlet is accessible and located in an adjacent cupboard.
Check the operation of the dishwasher:
1 Open door to turn dishwasher on
. Check with a
o
2 Select the Rinse programme:
3 Press > to start the Rinse programme. Can you hear the dishwasher filling?
4 When the Rinse programme is over (approx. 20 minutes), check that the water
has drained.
If a fault code appears, see the 'Fault codes' section of the User guide for advice.
15
Advertisement
Table of Contents
