Reversing The Door Swing - GE GTH18DCDBRBB Owner's Manual And Installation Instructions

Installation Instructions
INSTALLING THE WATER LINE
(CONT.)
I-_ PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall, Push the refrigerator back to the wall,
START THE ICEMAKER
On power switch models, set the icemaker power
switch to the/(on) position, On feeler arm models,
move the feeler arm to the ON(down) position,
The icemaker will not begin to operate until it reaches
its operating temperature of 15°F (-9°C) or below, It will
then begin operation automatically,
//
/;;
_" "_ Feeler Arm in the
STOP(up)position
FeelerArm in
the ON (down) position
NOTE: In lower water pressure conditions, the water
valve may turn on up to 3 times to deliver enough
water to the icemaker,
REVERSING THE DOOR SWING
IMPORTANT NOTES
When reversing the door swing:
, Read the instructions all the way through before
starting,
, Handle parts carefully to avoid scratching paint,
, Set screws down by their related parts to avoid using
them in the wrong places,
, Provide a non-scratching work surface for the doors,
IMPORTANT: Once you begin, do not move the cabinet
until door-swing reversal is completed,
These instructions are for changing the hinges from the
right side to the left side--if you ever want to change the
hinges back to the right side, follow these same
instructions and reverse all references to left and right,
Unplug the refrigerator from its electrical outlet,
Empty all door shelves, including the dairy
compartment,
TOOLS YOU WILL NEED
Phillips screwdriver
Masking tape
T20 or T25 Torx _driver,
whichever your model
requires
3/8" Head socket driver
(a 6-point socket is
recommended)
Putty knife or
thin-blade screwdriver
14