Replacing The Light Bulbs - GE GTH18DCDBRBB Owner's Manual And Installation Instructions

GEAppliances.com
Preparing for Vacation
For long vacations or absences, remove food
and unplug the refrigerator, Move the
refrigerator control to the 0 ('off)position and
clean the interior with a baking soda solution
of one tablespoon (15 ml) of baking soda to
one quart (1 liter) of water, Leave the doors
open,
Set the icemaker power switch to the O('oft_
position or move the feeler arm to the STOP
(up) position (depending on model) and shut
off the water supply to the refrigerator,
If the temperature can drop below freezing,
have a qualified servicer drain the water
supply system (on some models) to prevent
serious property damage due to flooding,
Preparing to Move
Secure all loose items such as grille, shelves
and drawers by taping them securely in place
to prevent damage,
Be sure the refrigerator strays in an upright
position during moving,
Replacing the light bulbs,
Setdng either or both controls to 0 (off) does not remove power to the light circuit.
Some modeh have only one light.
Refrigerator Compartment--Upper Light
A CAUTION: Light bu/bs m.y be hot, 0
Replace with an appliance
bulb of
the same or lower wattage,
Unplug the refrigerator, _ Plug the refrigerator back in,
0 The bulbs are located atthe top of the
compartment near the opening,
Freezer Compartment Dome Light ('on
some models)
A
CAUTION:Light be hot,
Unplug the refrigerator,
The bulb is located behind a light shield at
the back of the freezer compartment, To
remove, squeeze the top and bottom of the
shield and pull the shield off,
After replacing with an appliance bulb of
the same or lower wattage, replace the
shield,
Plug the refrigerator back in,