Installation Instructions; Refrigerator Location; Reversing The Door Swing - GE PBV10 Owner's Manual & Installation Instructions

Installation
Instructions
WARNING
To reduce the risk associated with choking, do not allow children under 3 years of age to have
access to small parts during the installation of this product.

REFRIGERATOR LOCATION

•
• Install it on a floor strong enough to support it fully loaded.
•
• This refrigerator is designed for built-in application. Air clearances for sides, top and back are not required.

REVERSING THE DOOR SWING

WARNING
off parts, or overtightening screws, can lead to the door
falling off and result in injury and property damage.
hardware and screws in this process for reinstal-
lation. Make notes of screw location during this
process for proper reinstallation.
This section demonstrates the process of changing
reversal from left to right can be done following the
same process.
Locate these parts in the Owner's Manual bag:
Left side upper
hinge cover
PARTS REQUIRED BUT NOT PROVIDED:
Top Mounting Bracket
TOOLS REQUIRED
Phillips
screwdriver
8
Left side
stopper
Left side
upper hinge
Ratchet Wrench with
PBV10
Removing Upper Hinge
right side to hold doors in place.
2. Remove the upper hinge cover.
screws that secure the upper hinge, then remove the
upper hinge.
hinge for future door swing reversal.
4. Tuck sensor into the sensor enclosure.
5. Remove the screw cover from left side where the
upper hinge will be installed and install the cover
onto right side.
6. Remove tape on refrigerator door. Hold the door
in place with one hand, depress door lock paddle
with the other hand to clear the lock bracket on the
mullion. Gently pull the door upward off the middle
hinge to remove the door and carefully put it aside.
Sensor Enclosure
Screw Cover
49-1000702 Rev. 1