Clearances; Location; Rollers - GE 19 Use And Care & Installation Manual

P FRJGE TOR LOCATION
Do not install the refrigerator where the
temperature will go below 60°E (16°C.) because it
will not mn often enough to maintain proper
temperatures.
Do install it on a floor strong enough to support
it fully loaded.
To keep energy costs down, avoid locating the
refrigerator next to the range or a heating vent.
CLEARANCES
Allow the following clearances for ease of
installation, proper air circulation and plumbing
and electrical connections:
Sides .............................................................. 3/4" (19 mm)
Top ........................................................................ 1 " (25 mm)
Back .....................................................................I" (25 mm)
If Model 19, 22, or 25 is to be installed against a wall
on the hinge side, allow 1½" (44 mm) for door
cleaz ance..
ROLLERS
(on some models)
The rollers have 3 purposes:
1. Rollers can be adjusted so the door closes easily
when opened about halfway (Raise the front about
3/4" [!9 mm] from the floor.)
2. Rolleis should be adjusted so the refrigerator is
firmly positioned on the floor and does not wobble.
3. Rollers allow you to move the refrigerator away
from the wall for' cleaning
To adjust the rollers:
1. Remove the base
grille by grasping the
bottom of the grille
and pulling it out_
2. Turn the two front roller
adjusting screws clockwise
to raise the refligerator,
counterclockwise to lower it,
3,
To replace the base
grille, line up the
clips on the back of
the grille with the
openings in the base
plate and push the
gri!le forward until
it snaps into place,
19