Table of Contents
Advertisement
Clearances
When installed into a corner: Allow 15" clearance on
the hinge side for a 130° opening and full extension of
bottom pans and pan removal.
The water line can be routed through
Electrical and
the floor or back wall.
Water
Connection
• The icemaker water line should be:
Locations
A 115 volt, 60 Hz. 15 or 20 amp power supply
is recommended. An individual properly grounded
branch circuit or circuit breaker is recommended, as
noted on the rating plate.
• Locate the electrical outlet within 5" x 7" shaded area
Between 74" and 81" from the floor.
Accessory
These models are factory set for 84" installation height.
Grille Panel
Adjustments to 83-1/2" or 84-1/2" heights can be made
Kits
by changing the grille panel.
Order ZGCSS36RH (right hand) or ZGCSS36LH (left
hand) Grille Panel Kit. These kits include 2 grille panels,
for 83-1/2" and 84-1/2" installation heights.
6
– Approximately 3-1/2" from the floor on the back wall,
or 3-1/2" from the back wall on the floor.
– At least 5" from either side of the opening.
shown.
– 2-1/2" from the left side.
Installation Preparation
36" Stainless Steel Refrigerators, Freezers
Two products installed side-by-side, both with hinges
on left sides (or right sides) will require a 2" min.
clearance between the products. The 2" min. separation
will prevent one door handle striking the handle on the
opposite product.
Electrical Outlet
Location 2 1/2"
5"
5"
3 1/2"
Important: To insure a flush fit and access to the power
cord, locate the electrical outlet as shown.
ZUGSS Unified Grille Panel Kit
For side by side installation, order ZUGSS grille panel
kit. This kit provides one continuous panel to span the
width of two products installed together for a unified
appearance.
7"
74"
Water Location
Advertisement
Table of Contents
