Mazda 5 Manual page 271

Mazda5_8CN3-EA-12I_Edition1 Page271
Tuesday, September 4 2012 1:24 PM
14. Prompt: XXXXXX - - - (Ex.
Stan's device ) (Device tag). Is this
correct?
15. Say: [Beep] Yes
16. Prompt: Pairing complete
After a device is registered, the system
automatically identifies the device. By
activating Bluetooth
or by activating Bluetooth
first after switching the ignition from OFF
to ACC, the system reads out a voice
guidance, XXXXXX - - - (Ex. Stan's
device ) (Device tag) is connected .
NOTE
Device registration can also be done by
l
operating the audio unit.
Refer to Bluetooth® Audio Preparation on
page 6-64.
Depending on the device, the registration
l
status may be lost after a certain period of
time. If this occurs, repeat the entire
process from Step 1.
qMaking a Call Using a Telephone
Number
NOTE
Practice this while parked until you are
confident you can do it while driving in a non-
taxing road situation. If you are not completely
comfortable, make all calls from a safe
parking position, and move out only when fully
under control and you can devote your eyes
and mind to driving.
1. Press the pick-up button or talk button
with a short press.
2. Say: [Beep] Dial
3. Prompt: Number, please
4. Say: [Beep] XXXXXXXXXXX
(Telephone number)
Form No.8CN3-EA-12I
®
Hands-Free again,
®
Hands-Free
Black plate (271,1)
Bluetooth® Hands-Free
5. Prompt: XXXXXXXXXXX.
(Telephone number) After the beep,
continue to add numbers, or say Go-
Back to re-enter the last entered
numbers, or press the Pick-Up button
to execute dialing.
6. (Dialing)
Press the pick-up button or say Dial ,
then go to Step 7.
(Adding/inputting telephone
number)
Say, XXXX (desired telephone
number), then go to Step 5.
(Telephone number correction)
Say, Go Back . The prompt replies,
Go Back. The last entered numbers
have been removed. . Then go back to
Step 3.
7. Prompt: Dialing
NOTE
The "Dial" command and a telephone number
can be combined.
Ex. In Step 2, say, "Dial 123-4567", then,
Steps 3 and 4 can be skipped.
Interior Comfort
6-79