Mazda 5 Manual page 175

Mazda5_8CN3-EA-12I_Edition1 Page175
Tuesday, September 4 2012 1:23 PM
If the warning light illuminates again even
after the tire pressures are adjusted, there
may be a tire puncture. Replace the
punctured tire with the temporary spare
tire (page 7-7).
NOTE
A tire pressure sensor is not installed to the
temporary spare tire. The warning light will
flash continuously while the temporary spare
tire is being used.
Warning light flashes
When the warning light flashes, there may
be a system malfunction. Consult an
Authorized Mazda Dealer.
qSecurity Indicator Light
This indicator light starts flashing every 2
seconds when the ignition is switched
from ON to ACC and the immobilizer
system is armed.
The light stops flashing when the ignition
is switched ON with the correct ignition
key.
At this time, the immobilizer system is
disarmed and the light illuminates for
about 3 seconds and then turns off.
If the engine does not start with the
correct ignition key, and the security
indicator light keeps illuminating or
flashing, the system may have a
malfunction. Consult an Authorized
Mazda Dealer.
Form No.8CN3-EA-12I
Warning/Indicator Lights and Beep Sounds
qHeadlight High-Beam Indicator
This light indicates one of two things:
l
l
qShift Position Indicator Light
This indicates the selected shift position.
In manual mode, the M of the shift
position indicator illuminates and the
numeral for the selected gear displays in
the gear position indicator.
Black plate (175,1)
Light
The high-beam headlights are on.
The turn signal lever is in the flash-to-
pass position.
(Automatic Transaxle)
Gear position indicator
Driving Your Mazda
5-51